dqsantos Posted December 3, 2013 Report Share Posted December 3, 2013 The last two times out I found that my Coiltek Blitz produced noise when the cable was touched or when the coil touched anything like a branch. Because of all of the junk at the last location I changed to my 11" Minelab DD and it did not have the same problem. I read that this could be due to not having the cable connector tight enough so I had it pretty snug. Any thoughts? Quote Link to comment Share on other sites More sharing options...
Admin nuggethunting Posted December 4, 2013 Admin Report Share Posted December 4, 2013 Hello Dqsantos, It's not normal for a coil to "false," especially the Blitz 14x9. Some of the older coils would false after they have been beaten around enough, so falsing when a coil gets older is not uncommon. However, new coils shouldn't just false when bumped, unless really bumped hard. Touching the coil wire can cause falsing, so its best to make sure the coil wire is secure around the shaft, not really loose and you secure it tightly at the connection (finger tight). Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.